Inhaltsverzeichnis
Verfügbare Sprachen
Verfügbare Sprachen
Electronic Sound
This model comes equipped with a digital sound circuit. A volume controller is located in
the smoke box behind the smoke box door (Figure 3).
Bell and Whistle: A short whistle sounds when the locomotive starts up. The departure
signal sounds only after the locomotive has been stopped for a long time, but not
continuously during switching operations. You can activate the bell and the whistle
(long whistle) with the LGB sound activation magnets (item no. 17050) included with this
model. The activation magnet can be clipped between the ties of most sections of LGB
track. The magnet is molded under the embossed LGB logo. If you place the magnet on
one side of the track, it activates the whistle when the locomotive passes over this spot.
When the magnet is placed on the other side of the track, the bell sounds.
Brakes: The sound of squealing brakes can be activated by means of the function button
for the multi-train system (see „Controllable Functions").
Sounds at a Standstill: About five seconds after the locomotive comes to a stop, the air
compressor sounds eight times. After a short pause the air compressor sounds again.
The sound of steam being let off is heard, and the sound of steam leaking from the boiler
will become softer until the electronic circuit shuts off.
Programming the Decoder
Numerous functions on the decoder can be programmed individually. To do this,
function values are programmed in registers (Configuration Variables - CVs). You also
can program the function values with the 55015 Universal Remote Controller.
• For normal operation, it is not necessary to change the function values.
• If programming results in unsatisfactory operation, you can reprogram the factory
pre-set values of most important CVs: Program register CV 55 to function value 55.
To reprogram the factory pre-set function values with the 55015, select program-
ming mode "P" (displays shows "P --"). Then input 6, 5, and 5 and press the right
arrow button. The display shows "P --" again: Input 5, 5, and 5 and press the right
arrow button again.
SERVICE
Lubrication
Oil the axle bearings and the side rod bearings now and then with a drop of Märklin
oil (item no. 7149).
Replacing Light Bulbs (E130023)
Lamps (front, above in the rear): Remove the ring on the outside of the lamp glass.
Carefully lift the glass from the lantern. Pull the light bulb from the socket with a pair
of tweezers. Insert the new light bulb. Put the model back together.
Interior Lighting: Pull the light bulb from the socket with a pair of tweezers. Insert the
new light bulb.
Replacing Traction Tires (E126174)
• Loosen the hex head screw on the rear drive wheel with a traction tire.
• Remove the side rods and drive rods.
• Use a small flat blade screwdriver to remove the old traction tire: Lift the old
traction tire from the groove in the driving wheel.
• Carefully push the new traction tire over the wheel and into the groove.
• Make sure that the traction tire is properly seated.
• Put the model back together.
Replacing the Smoke Unit
• Pull the cover from the smoke stack (Fig. 4).
• Remove the damaged smoke unit (smoke stack insert) from the smoke stack with
needle nose pliers or a pair of tweezers (Fig. 5).
• Cut the wires.
• Connect the wires to the new smoke unit. When doing this twist the ends of the
wire that have had insulation stripped from them and insulate them from contact
with other wires (Fig. 6).
• Push the new smoke unit into the smoke stack.
• Put the model back together.
9
Inhaltsverzeichnis
