Seite 1
Montageanleitung Control unit i5CAxxxx Mounting Instructions Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: [email protected]...
Seite 2
Beachten Sie die Sicherheitshinweise! Informationen zur Verdrahtung und zur Inbetriebnahme finden Sie in der Montage- und Einschal- tanleitung des Inverters. Informationen und Hilfsmittel rund um die Lenze-Produkte finden Sie im Internet: Lenze website à Download Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: [email protected]...
Seite 3
Montage Wichtige Hinweise Montage Wichtige Hinweise GEFAHR! Gefährliche elektrische Spannung Mögliche Folge: Tod oder schwere Verletzungen ▶ Alle Arbeiten am Inverter nur im spannungslosen Zustand durchführen. ▶ Nach dem Abschalten der Netzspannung mindestens 3 Minuten warten, bevor Sie mit den Arbeiten beginnen.
Seite 4
Montage Montageschritte Montageschritte Sie benötigen: • Torxschraubendreher TX20 1. Vorbereitung: 1. Schirmblech in die Aufnahme auf der Rückseite einschieben bis es einrastet. 2. Montage: 1. Control unit in die oberen Befestigungsschlitze einhaken. 2. Nach unten drehen, bis es in die unteren Befestigungsschlitze einrastet. Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: [email protected]...
Seite 5
Montage Montageschritte 3. Mit Sicherungsschraube befestigen.. TX20 1.3 Nm 11.5 lb-in Die Control unit ist montiert. Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: [email protected]...
Seite 6
You will find information on wiring and commissioning in the mounting and switch-on instructions of the inverter. Information and tools with regard to the Lenze products can be found on the Internet: Lenze website à Download Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: [email protected]...
Seite 7
Mounting Important notes Mounting Important notes DANGER! Dangerous electrical voltage Possible consequence: death or severe injuries ▶ All works on the inverter must only be carried out in the deenergised state. ▶ After switching off the mains voltage, wait for at least 3 minutes before you start working. Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: [email protected]...
Seite 8
Mounting Mounting steps Mounting steps You need: • Torx screwdriver TX20 1. Preparation: 1. Insert the shield sheet into the slot on the back side until it engages. 2. Mounting: 1. Hook the control unit into the upper mounting slots. ...
Seite 9
Mounting Mounting steps 3. Fix it with a securing screw. TX20 1.3 Nm 11.5 lb-in The control unit is mounted. Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: [email protected]...