Verfügbare Sprachen
Verfügbare Sprachen
OPERATING INSTRUCTIONS
Remote control
Remote control is supplied as a standard accessory.The
heater has a freely adjustable. Batteries, with a life
expectancy of approximately one year, feed the electrical
supply.The remote control will only work if the pilot light
is lit.
Connecting the Receiver
The remote control system comprises a receiver and a
remote control, packed together in one box. The receiver
must be connected to the appliance fitting the batteries.
This is done as follows:
• Take the receiver out of the box.
• Slide the white plug of the cable onto the receiver circuit
board (fig. 8).
• Connect the wires to the connectors on the gas control
valve.The different sized plugs correspond with the
connectors on the gas control valve.
• Open the lid.
• Insert 4 penlight batteries
(type AA). Make sure they are
the right way round.
• Replace the lid.
• Place the receiver under the
appliance on the floor. Make
sure that the red LED points
forwards. Place the reciever
as far away from the burner
tray as possible to prevent
the reciever from getting too
hot.
Replacing the batteries in the receiver
• Open the door at the front.
• Take the receiver and open the cover.
The batteries are under that cover.
• Remove the old batteries and insert the new ones, making
sure that the + and – signs on the batteries correspond
with those in the holder.
Inserting or replacing the batteries
in the remote control
• Remove the cover on the back of the remote control.
• Connect a square battery (type 6LR61) to the clip.
• Fit the battery in the holder.
• Replace the cover.
• The temperature is shown on the display in Fahrenheit,
press both buttons for a few seconds and it will change to
Celsius.
NB: Do not throw old batteries in the dustbin.They
should be treated as Chemical Waste.
OPERATING INSTRUCTIONS
Lighting
Press button A and turn to the left to the small flame
fig. 8
The flame will ignite at
that is the case, hold button A firmly pressed for another 5
seconds.Then release button A and check that the pilot
light is still burning. Now turn button A to the large
flame
block. Depending on the setting of the control button B,
high or low flames will be visible.
Manual operation
Button B (fig. 6a) regulates the height of the flames.
Remote Control
The height of the flames can be regulated by remote
control, which will turn button B (fig. 6b) on the gas
control block. Press the bottom button on the remote
control for a smaller flame; press the upper button for a
higher flame. Manually adjusting button B will have the
same effect. A certain force is required when rotating
button B, a clicking sound is quite normal.
Pilot light setting
If the heater is not in use but you would like the pilot light
to remain alight, set button A to the small flame.The gas
supply to the main burner will then be switched off.
18
A
fig. 6a
fig. 6b
. Check that the pilot is alight. If
, which will open the main valve of the control
B
.
Kapitel
