Maintenance And Servicing; Eu Declaration Of Conformity - Rupes HR81M Übersetzung Des Original Betriebsanleitung
Vorschau ausblenden
Andere Handbücher für HR81M:
- Betriebs- und instandhaltungsbuch (141 Seiten) ,
- Originalbetriebsanleitung (8 Seiten)
Inhaltsverzeichnis
Verfügbare Sprachen
Verfügbare Sprachen
Displayed emission values are comparative and are to be employed for a provisional assessment of the operator's risk exposure
during the work period. Appropriate evaluation of work period must also include tool's idle and stop periods. These emission values
represent the tool's main applications. If the tool is used for other applications, with other accessories, or if it does not undergo
regular maintenance, emission values can significantly increase during operations.
CAUTION: The indicated measurements refer to new power tools. Daily usage causes the noise and vibration values to
change.
MAINTENANCE AND SERVICING
WARNING: To reduce the risk of injury, turn unit off and disconnect it from power source (when machine is connected
to a power supply) or battery pack (when machine is connected to a battery pack) before installing and removing
accessories, before adjusting or when making repairs. Be sure the switch is in the "OFF" position. An accidental
start-up can cause injury.
CLEANING
At the end of each work session, or when required, remove any dust from the body of the tool using a soft cloth, paying particular
attention to the motor ventilation slots.
LUBRICATION
This tool has been lubricated with a sufficient amount of high grade lubricant for the life of the unit under normal operating conditions.
No further lubrication is necessary.
REPAIRS
Maintenance and cleaning of the inner parts like ball bearings, gears etc. or others, must be carried out only by an authorized
customer service workshop.
DISPOSAL (WEEE DIRECTIVE)
For EU countries only: According to the European Directive on Waste from electrical and electronic equipment and its
implementation in conformity with national standards, exhausted electrical equipment must be collected separately, in order
to be recycled in an environmentally friendly way. The product, when it reaches the end of its life, must not be dispersed in
the environment or thrown away as household waste. It must be disposed at authorized recycling centres (contact your local
authorities to know where to dispose of the product according to the law). The correct disposal of the product contributes to the
health and preservation of the environment. Illegal disposal of the product will entail penalties against the offenders.
Rupes BIGFOOT iBrid NANO tool Part Numbers:
HR81M
HR81ML
9HC120LT
9HB125LT/9HB120LT
9HP120LT
EU DECLARATION OF CONFORMITY
We declare on our responsibility that the represented tool is in conformity with the directives:
2006/42/EC, 2014/30/EU, 2011/65/EU.
The tests have been carried out in accordance with standard:
EN 62841-1:2015 + AC:2015
EN 62841-2-3:2021 + A11:2021
EN 62841-2-4:2014 + AC:2015
EN 55014-1:2021
EN 55014-2:2021
EN 61000-3-2:2019 + A1:2021
EN 61000-3-3:2013 + A1:2019 + A2:2021
IEC EN 63000:2018
12
– Short neck Rupes BIGFOOT iBrid NANO tool
– Long neck Rupes BIGFOOT iBrid NANO tool
– Li-ION Battery Charger
– Li-ION Battery pack
– Rupes BIGFOOT iBrid NANO tool Power Supply
Vermezzo (MI), 14/06/2022
Via Marconi, 3/A - Loc. Vermezzo
20071 - VERMEZZO CON ZELO (MI) - Italy
The President
G. Valentini
Technical file at:
RUPES S.p.A.
Inhaltsverzeichnis
