Inhaltsverzeichnis
Verfügbare Sprachen
Verfügbare Sprachen
The appliance is not qualified for continuous operation. Allow
the appliance to cool down for about 2 minutes after every
vacuum-sealing cycle.
Prevent suction of liquids into the vacuum chamber. In the event liquids
enter the vacuum chamber, please remove them with a towel.
After each use pull the mains plug for safe switch-off.
Never immerse the casing, power cord and mains plug in water for
cleaning.
Only operate appliance and accessories in dry condition.
Prior to initial use
For a start, please clean the appliance as well as all accessories. For more detailed information please refer to "Cleaning
and maintenance".
Operating the appliance
NOTE: Do not store the appliance with LOCK-buttons locked.
Vacuum sealing with plastic bags or rolls
Always place the appliance on a dry, stable and level base. Please provide for sufficient space in front of the appliance to
place the bags with the food to be vacuum-sealed.
Connect the mains plug to a socket corresponding to the voltage the appliance is designed for (see technical data) and
switch on the appliance using the main switch (the green control light will light up).
Only use genuine Rommelsbacher Magic Vac
widths: 20 cm and 30 cm. Opt for the bag size suitable to accommodate your food to be preserved. Make sure that the
bag is at least 8 cm longer than the food to be vacuum-sealed.
A) Vacuum sealing with bags
Open the cover (8) completely.
Put the food into the bag, however without creating wrinkles or straining the surface of the bag. Remove any liquids
and particles from the area of the bag's inner surface where the sealing seam is meant to be.
Put the bag with its contents in front of the appliance and place the bag's open edge into the vacuum chamber (15)
(fig. H).
Shut the cover (8). First press down on both sides of the cover with your thumbs and then press the LOCK-buttons
(12) so that they lock in place (fig. I). The appliance will start the vacuum sealing cycle automatically. Wait until the
SEAL MIN indicator (6a) or the SEAL MAX indicator (6b) stops blinking.
Press the manual valve (9) (fig. L).
Open the cover and remove the bag.
Check the sealing seam. A correct sealing seam should be a smooth straight seam without wrinkles and the seam
should no longer show any design of the lower layer (fig. G).
The appliance can be stopped at any time by pressing the manual valve (9). The appliance only stops when the cover
is lifted.
22
®
vacuum bags/rolls with grooved structure. The bags are available in two
Inhaltsverzeichnis
