Inhaltsverzeichnis
Verfügbare Sprachen
Verfügbare Sprachen
g) Deletion Mode "CLr"
Here, two functions are available:
"CLr USEr SEt"
"CLr ALL dAtA"
• If you have set the limit for alarm at overload before selecting the deletion
mode (see f), you can continue with the next step right away.
Otherwise, the setting mode must be started by pushing the button "SET"
(3) for approx. 3 seconds. The upper left of the display shows "SET" and the
upper display line shows "24 Hr".
Briefly push the button "
• The top of the display shows "CLr"; the deletion mode can be activated here.
• Briefly push the button "SET" (3); the bottom of the display shows "CLr ALL
dAtA".
• Use the button "
modes.
"CLr USEr SEt"
All settings are reset to factory settings (power tariff, limits for standby power
intake, GHG/CO
"CLr ALL dAtA"
All measured data are deleted (kWh, energy costs, operating term, maximum
storage for power/current).
• To delete the data, keep the button "OK" (2) pushed for 3 seconds until a
beep sounds.
The selected data have now been deleted. The setting mode is left automati-
cally and the normal display of the meter returns.
• To leave deletion mode without deleting any data, keep the button "SET" (3)
pushed for 3 seconds. Then the regular display appears again.
50
The home technology brand for the entire house. More information at www.sygonix.com
All measured data are deleted and all settings are reset to
factory settings.
Only the measured data are deleted. This is recommended
if any other consumer is connected or if you want to restart
measuring.
" (5) 5x to get to the deletion mode, see next step.
" (6) or "
" (5) to switch between the two deletion
-emission value, overload alarm).
2
Kapitel
Inhaltsverzeichnis
