Inhaltsverzeichnis
Verfügbare Sprachen
Verfügbare Sprachen
Operating Manual
General description
Genelec G One and G Two are compact two way
active loudspeakers designed to produce broad
bandwidth sound with high output and low colora-
tion.
Positioning the loudspeaker
Each loudspeaker is supplied with an built-in ampli-
fier unit, signal cables, mains cable and an operat-
ing manual. After unpacking, place the loudspeak-
ers in their required listening positions, pointing
them to the center of the listening area. If possible,
place the listening position to the central line of the
room and the loudspeakers at equal distance from
the walls.
Connections
Before connecting up, ensure that the power switch
on the signal source is set to OFF.
Audio input is via an unbalanced RCA connec-
tor. Only line level audio signal from a preamplifier,
computer sound card or similar signal source can
be connected, never a high power signal from the
speaker terminals of a power amplifier. Once the
connections have been made, the loudspeakers are
ready to be switched on.
Autostart function
The signal sensing Autostart function of the loud-
speakers powers them up when playback begins.
6 English
G One and G Two
Active Loudspeakers
Automatic powering down of the loudspeakers
happens one hour after the playback has ended
and the loudspeakers go to standby mode. The
power consumption in standby mode is less than
0.5 watts. The loudspeaker will automatically and
rapidly start once an input signal is detected from
the source.
Switching off the power indicator
LED (G Two only)
The power indicator LED of the G Two can be
switched off by turning the "LED OFF" switch on the
back panel to "1".
Setting the tone controls
The frequency response of Genelec G One and
G Two can be adjusted to match the acoustic en-
vironment by setting the tone control switches on
the rear panel. The controls are "Tabletop" and
"Bass". Table 1 shows some typical settings in
various situations. Figures 2 and 3 show the ef-
fect of the controls on the frequency response.
Tabletop
This switch is recommended to be switched to
"1" when the loudspeakers are placed on a table
or similar surface, such that there is a reflective
surface between the loudspeaker and the listener.
Such a placement typically causes a boost at cer-
tain bass frequencies, which the "Tabletop" func-
tion is designed to compensate for.
Inhaltsverzeichnis
