Inhaltsverzeichnis
Verfügbare Sprachen
Verfügbare Sprachen
Loudspeaker Mounting Position
Flat anechoic response
Free standing in a damped room
Free standing in a reverberant room
Near to a wall
Near field on a reflective surface
In a corner or a cabinet
Table 1: Suggested tone control settings for different acoustical environments
Mounting considerations
Align the loudspeakers correctly
Always place the loudspeakers so that they are
aimed towards the listening position. Vertical place-
ment is preferable, as it minimizes acoustical can-
cellation problems between the drivers around the
crossover frequency.
Maintain symmetry
Check that the loudspeakers are placed symmetri-
cally and at an equal distance from the listening
position. If possible, place the system so that the
listening position is on the centerline of the room
but not exactly at the center of the room. Place the
loudspeakers are at an equal distance from the
centerline and also at an equal distance from the
listening position.
Minimize reflections
Acoustic reflections from objects close to the loud-
speakers like desks, cabinets, computer monitors
etc. can cause unwanted blurring of the sound image
and also cause frequency response problems. These
can be minimized by placing the loudspeaker clear of
any hard surfaces.
8 English
Tabletop
OFF
OFF
OFF
OFF
ON (-4 dB @ 200 Hz)
OFF
Minimum clearances
Sufficient cooling for the amplifier and functioning of
the reflex port must be ensured if the loudspeaker is
installed in a restricted space such as a cabinet or
integrated into a wall structure. The surroundings of
the loudspeaker must always be open to the listening
room with a minimum clearance of 5 centimeters (2")
behind, above and on both sides of the loudspeaker.
The space adjacent to the amplifier must either be
ventilated or sufficiently large to dissipate heat so
that the ambient temperature does not rise above 35
degrees Celsius (95°F).
Mounting options
The G One and G Two offer several mounting op-
tions: The Iso-Pod™ (Isolation Positioner/Decou-
pler™) vibration insulating table stand allows tilting
the loudspeaker for correct vertical alignment. On the
base of the loudspeaker is a 3/8" UNC threaded hole
compatible with a standard microphone stand. On
the rear there are threaded holes for Omnimount
brackets. G One also has threaded holes for Sanus
and VESA brackets.
Bass
OFF
OFF
-2 dB
-6 dB
-2 dB
-6 dB
®
Inhaltsverzeichnis
