Inhaltsverzeichnis
Verfügbare Sprachen
Verfügbare Sprachen
Pos: 96 /Technische Dokumentation/Betriebsanleitung/Inbetriebnahme/TOP/Ausführung ohne Schwimmer TOP @ 6\mod_1458745885883_370.docx @ 79265 @ 3 @ 1
6.2.2
Design without float switch
1.
Insert the plug. The pump will turn itself on.
2.
When the minimum water level has been reached,
disconnect the power supply and remove the plug if
necessary.
Pos: 97 /Technische Dokumentation/Betriebsanleitung/Inbetriebnahme/TOP/Kontrolle TOP @ 6\mod_1458745999357_370.docx @ 79282 @ 2 @ 1
6.3
Control
Following installation, the length of the float cable should be
adjusted to correspond to the water level.
Ensure that the pump does not exceed the maximum switch
procedure per hour.
Pos: 98 /Technische Dokumentation/Betriebsanleitung/Inbetriebnahme/TOP/Pumpe ausschalten TOP @ 6\mod_1458745671132_370.docx @ 79231 @ 2 @ 1
6.4
Turn the pump off
1.
Slowly close the valve in the pressure line in order to avoid a
backflow.
2.
Turn the pump off.
Pos: 99 /Technische Dokumentation/Betriebsanleitung/Inbetriebnahme/TOP/Außerbetriebnahme @ 6\mod_1458722257285_370.docx @ 79162 @ 2 @ 1
6.5
Decommissioning
1.
Turn the pump off by disconnecting the power supply.
2.
If necessary, disassemble the pressure line.
3.
If necessary, release the screws from the contact area.
4.
Take the connection cable in your hand.
5.
Lift the pump using the handle. Depending on the weight, use
lifting equipment.
Pos: 100 /Technische Dokumentation/Allgemeine Module/#### Seitenumbruch #### @ 0\mod_1426069111812_0.docx @ 891 @ @ 1
11|2016
Start-up/shut down
EN 23
Kapitel
Inhaltsverzeichnis
Fehlerbehebung
