Inhaltsverzeichnis
Verfügbare Sprachen
Verfügbare Sprachen
If you have hard water ,it is advisable to use
•
only distilled or demineralized water.
Do not use chemically delimed water or
•
perfumed
STEAM IRONING
1.Fill the iron as described in the section "how
•
to fill the water tank".
2. Plug the iron into the mains.
•
3.Steam ironing is possible only when hea-
•
ting is complete.Otherwise ,water may escape
through the soleplate.
4. Wait until the indicator does not flicker to
•
prove that the bottom plate has been heated.
5.Press Steam switch to realize Steam ironing.
•
Fig. 4
6.When the iron is finished, place the iron in an
•
upright position or on the base when the iron
is interrupted
7.Disconnect the iron from the mains supply.
•
Pour of any remaining water and leave the iron
to cool off.
CONTINUOUS STEAM
Heating completed, temperature stabilized
•
2.Start steam switch, can choose large steam
•
or ECO steam at the same time, the two stalls
can be switched at any time. Fig. 5
SHOT OF STEAM
When the heating is completed, the tempe-
•
rature is stable.
Press the steam in two seconds quickly, and
•
the steam will start to explode in two seconds,
while the steam will flash for 2 seconds. Fig.6
SELF CLEANING
1.Please make sure there is enough
•
water in
the tank before cleaning
2.Please put the iron in a safe position before
•
cleaning to prevent people from being injured
by hot water during cleaning
3.After the heating is complete , the long press
•
the cleaning switch for 3 seconds , and the iron
enters the cleaning mode .The display on the
screen flashes and goes with the 3 sound of
bees. Fig. 7
4.Two minutes later, the buzzer rang three
•
times, indicating that the cleaning was
complete.
AUTO SHUT OFF
When the iron is stationary for more than 7
•
minutes, the iron goes out of power mode
The poweroff sign flashed on the display, ac-
•
companied by six buzzing sounds
Press the steam switch to restore the power
•
Irons will not be cut off during steam discharge
•
If you need stop the process switch off the
•
item
ANTI DRIP
This iron is equipped with a drip stop function:
•
the iron automatically stops steaming when
the temperature is too low to prevent water
from dripping out of the soleplate.
ANHYDROUS DETECTION (NO WA-
TER DETECTION)
In the course of working, if there is no water
•
in the water tank, the pump will automatically
stop working to protect the life of the pump
DEFECTS AND REPAIRS
Do not attempt to replace a defective mains
•
lead .The appliance has to be returned to an
authorized service centre for repair.
CORD STORAGE
Follow Fig. 8
•
FAULTSREASONS AND SOLUTIONS
IRON EMITS AN ODOR OR SMOKE
Iron gives off an odor when turned on for the
•
first time. Oils used during manufacture need
to be burnt off allow ten minutes for odor to
disappear.
IRON DOES NOT HEAT
The iron should be plugged into a 230 Volt ,
•
Whether the power switch is turned on
IRON DOES NOT STEAM
The water tank many be empty. Turn off the
•
steam regulator and add water. Allow the iron
to heat, and then set the turn on to the steam
setting.
IRON IS LEAKING
The temperature setting is too low to produce
•
steam. Shot of steam used too much, allow
iron to re-heat.
ANOMALIES AND REPAIR
Take the appliance to an authorised technical
•
EN
Inhaltsverzeichnis
